How to check the ignition coil

In the life of any driver, non-standardThe situation when some systems in the car stop working. Any malfunction can occur right on the road, at the most inopportune moment for this. In no case can not panic in such situations. It is necessary to gather strength and try to eliminate such a malfunction in the car. Very often, drivers face the problem of the ignition system. As a rule, the machine simply does not start. How to check the ignition coil using improvised means on the road? Such questions arise for any driver who often leaves the territory of his native city.

Modern cars of various production can have a non-contact ignition system. Verification of such a system is not difficult, so it can be done with a tester.

How to check the coil ignition, any driver knows. This check can be carried out at home, as well as at special service stations that can offer additional services to repair your car. Very often drivers try to check the ignition coil at home. Many do such work for the first time without any fear.

Before proceeding with the verificationignition system, you need to make sure that there is no spark. Next, you need to disconnect the connector that connects to the switch. It is important to connect the instrument correctly to the terminal blocks, and then turn on the ignition system in the car. The voltmeter should show the voltage of the battery. It often happens that the value obtained can not always correspond to what was expected to be seen. In this case, it is recommended to check the wire that goes from ignition to the coil. If the wire is damaged, it must be replaced. Damaged items can interfere with other devices, so they are always recommended to change to working.

After changing the wire, you need to connect toother connector pads. Again, it is recommended to turn on the car ignition system and evaluate the results of the instrument scale. The tester should display the voltage that corresponds to the battery voltage. If this identity does not occur, then disconnect the wire from the battery, then switch and measure the resistance between the switch and the plus, as well as the terminal and minus. After you have to add the data. You will have a result of 0.2 Ohm. Such actions are recommended to be carried out only with the car ignition system turned on.

How to check the ignition coil and while not spending much energy, thinksmost drivers. Inspection of it will lead to the identification of the plug in the upper part of the ignition system. After this, it is necessary to measure the resistance of the primary winding. The rate of this resistance should be 0.9 Ohm. The same must be done with the secondary winding.

How to check the ignition coil VAZ, can prompt professionals in this matter. As a rule, such works can be performed at the service station. Qualified experienced specialists will solve the problem in about half an hour. Checking the ignition coil is carried out on a specially equipped stand, by means of which the speed of the trambler is simulated. Sparks must appear in any rotation of the coil.

how check the ignition coil, having a little knowledge in this area? It is necessary to use the ammeter, which is located at some cars on the panel of devices. The ammeter needle will be at zero if the ignition coil is faulty. In this case, without delay, you should change it, not forgetting the observance of the polarity when installing a new coil.