How to set up a subwoofer in the car? Step-by-step description of the process

The subwoofer is the dream of many car owners. With this device, you can endlessly enjoy the tones of music and look at the envious eyes of other drivers. But after buying and installing this device, you should not relax, since it is still half the battle to properly install the subwoofer into the car. To make it sound good, you need to adjust it correctly.

Therefore, after the acquisition of this device, almost all motorists are wondering "how to adjust the subwoofer in the car." The answer to it you will learn in today's article.

First of all, after installing thistool you need to reset all the settings of the head unit. After that, select the LPF position on the filter amplifier for the channel and set the required frequency (approximately 50-70 Hz). After this, it is necessary to translate the filter for the front channel to the HPF position. The mechanism itself is on the amplifier. The frequency of the channel must be at least 70 and not more than 90 Hertz.

If you apply passive division, onAt this stage, the question "how to adjust the subwoofer in the car" for you will be completed. However, if you use channel gain, you still have a lot of work to do, because, apart from the amplifier, you will have to adjust the speakers separately. In this case, set the channel filter to the HPF position and adjust it to a frequency of 2500 Hertz.

After that you need to adjust the sensitivityspeakers. To do this, reset the frequency of the amplifier to zero, and the volume of the sound is maximized. Then turn the sensitivity knob towards the upward direction. If, after these settings, you notice that the sound is distorted, decrease the value of the knob.

After all this, we check the quality of work. Ideally, the sound should come from the subwoofer without any distortion or interference. But even if the music sounds good, the question "how to adjust the subwoofer in the car" is not exhausted. Pay special attention to the moment when the audio system is turned off. If at this time you hear a strange sound in the form of a crack or clicks, know: in the speakers there is interference with the signal. To resolve this issue, check the wiring layout of the entire system. Remember that you need not only to be able to properly adjust the speakers, but also correctly install the subwoofer with your own hands in the car. If necessary, move these wires to a different location. If there are basses in the back, and this should not be, connect the device in the opposite phase of the amplifier. To do this, you need to rotate the phase control by 180 degrees, which is located on the body of the subwoofer. If this is not the case, just swap the "+" and "-" speaker wiring. Then you will have a feeling that the music does not come from behind, but from the middle of the cabin. No jamming and distorted sounds from the subwoofer will not come.

At this, the adjustment of the speakers can be considered complete. After completing these steps, you will no longer be wondering "how to adjust the subwoofer in the car."