Finishing plasterboard

It is unlikely that someone will disagree with the fact thatgypsum board - one of the most demanded building materials. Repair and interior decoration of premises with its help is a widespread phenomenon. This environmentally friendly, fire-resistant, energy-saving material is widely used in creating a modern interior, embodying the most intricate fantasies of people.

Drywall - composite material from gypsumcore with technical foam, is faced with cardboard. Gypsum passes air well, maintaining a constant moisture regime in the room. The material is completely non-combustible, non-radioactive, non-toxic, has low thermal conductivity and high sound insulation, is easy to use, it can create a fantasy curved surface or "drape" the tortuous surface. It is made of decorative partitions, window slopes, arches, multi-level ceilings, mansards and sewing utilities.

Finishing plasterboard slopes can beis accomplished in two ways. In one case, the adhesive is glued directly onto the walls. In the second (if the unevenness is too great or you need to reduce the opening), the sheets are attached to the metal frame by screws. Then - treatment with antifungal primer, puttying, cleaning, painting. On plasterboard can be glued thin plastic. By the way, for the finishing of slopes should use a moisture-resistant version. Finishing plasterboard is good in that the slopes are repairable - if scratched, broken off a piece, you can always patch and paint over.

Alignment and plasterboard wall finishing is performed in exactly the same way as slopes.

Along with the metal frame, you canuse wooden bars. There are several points that deserve attention. To make the inner corner, the sheet is set in place, the ruler marks and cuts the cardboard on the side facing the wall. Then the sheet is neat, so it does not break, bends around the corner and is fixed.

For facing outer corners from the insidea triangular groove is cut out and the sheet is bent along the facing corner. Protect the corners from damage to the paint corners. Stitches in the joints of the sheets are sealed with plaster mastic, and to keep it better, wooden slats are smeared with liquid mastic. Then, a mesh or gauze is pasted onto the seam, and it is shpatlyuetsya to the level of the sheet for further finishing. The ideally smooth surface of plasterboard sheets is suitable for any finish: painting, wallpapering, tiling, decorative plaster.

Of gypsum cardboard it is fairly easy to assemble a quick-erectable skeleton partition or decorative with niches, arches or several levels.

Finishing plasterboard ceilings, especiallymultilevel, of course, more difficult to finish the walls. But how much this diversity of your interior, make it individual and unique! In such a ceiling, it is easy to install spotlights that add expressiveness and give additional lighting where planned. If very high ceilings - it is easy to lower them to a comfortable level.

Decorating with gypsum cardboard doorways in the form of arches, semi-arches with niches and decorative protrusions will make your home irresistible.

Under plasterboard it is convenient to place or hide plumbing, electrician, low-voltage communications and everything that hinders you.

Not so terrible, as it seems at first glance,interior plasterboard with their own hands. Carefully read the advice of specialists and people who have done a similar job, rethink, accurately imagine what you want, pick up a tool and a partner (with large sheets it is easier to work together), gently measure the size - and go ahead. Necessary tools: a screwdriver, a perforator, a jigsaw, a hammer, a screwdriver, a level of at least two meters, a padded thread, a hacksaw, a knife and a square. Its work is much cheaper, in quality can be on top, will bring moral satisfaction and joy of creativity.