SITE SEARCH

What is "ringing"?

Modern fishing stores are more likean exhibition of the achievements of modern science and technology: ultra-light, super strength materials and tackles, an incredible choice of ready-made baits and bait, fishing lines for every taste and catch. Meanwhile, our fathers and grandfathers did well without these "expensive toys" and used simple, but very effective ways, such as catching a ring. It is about him that will be discussed in our article.

ringing

What does it mean "catching a ring"

It is believed that this old method was invented bylower Volga, which, in general, is natural. After catching fish on the ring is effective only in places of strong and smooth flow and exclusively from the boat. This method is considered very catchy and unsportsmanlike, and that is why it is banned in some regions of Russia, although it does not differ in any way from catching a spinning rod or fishing rod. However, Russian legislation is not the topic of this article, and therefore we will return to fishing. So, catching on the ring is as follows: a large amount of bait (to the composition will be returned later) and a heavy load are placed in a fine mesh net (feeder), which on a thick line is lowered to the bottom. The end of the line is tightened to the side of the boat. Then the usual short rod is taken, to the line of which is attached a sinker in the form of a ring with a slot and a leash with hooks. The hooks are planted with bait. After that, through the slot put the ring-sinker on the line, to which the feeder is tied, and sent to the bottom. The ring rests on the trough, and the leash with hooks unfolds along the stream, and along with the path washed from the mesh of bait. If the fish is, then catching the ring definitely guarantees a solid catch.

fishing on the ring

Tackle manufacturing

Buy a ring in a specialty store,most likely, it will not be possible, but it is easy to make it yourself. To do this, in any suitable form (it can even be squeezed out in the ground), a ring with a diameter of 3-5 centimeters is poured out of the lead. Grinding the resulting billet from the tides and burrs, you need to drill a small hole in it. In it will be a fishing line with a winding ring, to which the leashes with hooks are tied. In one place at a 45-degree angle, a through-hole is made for the metal hacksaw. Through it, the ring should be put on the line with the feeder.

Bait

In the feeder used to fall asleep just boiledpearl or millet porridge. But earlier, they say, there were more fish, so now it will be better to add corn, parsley, some cereals or cut worms to the composition. The main thing is that there must be large particles in the bait, and that the size of the feeder cells allows the feed to be washed out a little. This rule is mandatory if it is planned, for example, to catch bream on a ring.

catching bream on a ring tackle

Tackle

They are extremely simple. This rod is no longer than 70 cm, equipped with an ordinary coil with a line up to 20 meters and a diameter of 0.5 mm. For fishing leashes you can take a little thinner. Between the hooks distance, as a rule, choose a half meter.

Conclusion

In conclusion, a few more tips. The place for fishing should be chosen as deep as possible. So that the boat or its shadow can not be seen. If a vegetable bait, then the bait is good to use an animal, so to speak, for a change.

</ p>
  • Rating: