Tinting car windows with your own hands: recommendations

Motorists make their windows tintedauto for various reasons. Someone wants to make the car more attractive, someone cares about their health. Toning of car windows can be done for one of six reasons, or all at once.

Causes

- First of all, by means of this procedure you can reduce by 60% the heating of the cabin in the summer days.

- Tinted windows can hold up to 99% of ultraviolet radiation, which is harmful, protecting people inside the cabin from skin cancer.

- If there is a lateral collision of cars, then through toning it is possible to keep the broken parts of the glass, protecting against cuts.

- With its help it is possible to fight with dangerous gleams from the sun, snow, and also headlights of cars, going to a meeting.

- Through toning you can protect your personal space, that is, to hide from the prying eyes the contents of the salon.

- Due to harmful sun rays,to suffer plastic and internal upholstery of the car, which crack and burn out under such influence. Allowed tinted windows of the car does not allow this to happen.

Technology

The effect of toning is obtained bysticking a special film to automotive glasses. It is made of polyester, which has a very thin layer of paint and metal composition. Toning of car windows with your own hands using such a film is not particularly difficult. Fix the film on the inside of the glass. So it will be protected from mechanical damage in the form of rain and snow. Before starting the work, you should thoroughly clean the surface of the glass from grease and dirt. To tint windows of the car with your own hands was successful, you should prepare a perfectly smooth surface without sputtering and chips. If there are irregularities, air bubbles may form in their area.

Toning of car windows, the price of which can be from 1500 rubles, is made in several steps. When you prepare all the necessary materials for work, you can proceed.

Glass should be washed as thoroughly as possible andclean with a soap solution with a scraper, after which it will be possible to cut out the tem- perature and then cut the film already. It is necessary to carefully remove a small part of the liner, moisten the film from the spray gun, then start applying it on the glass soaked with soapy water beforehand. During the removal of the liner, always wet both surfaces and apply a tint evenly.

Toning of car windows with own handssuggests that after the film has been glued completely, you will need to take a rubber spatula, with which the movements from the center to the edges remove all air. You can use an industrial hair dryer, which will allow the film to lie better.

If you follow the instructions, you can geta fairly good result. It is easiest to glue the film on a smooth removable non-convex glass, but the toning of non-removable rear windows may become a bit problematic. However, it is important to understand that the technology remains the same regardless of the type of glass.

</ p>