Shower cabin with own hands

The modern market offers a lot of readysolutions, that is, you can safely buy a shower, while not particularly bothering. However, many people think that the shower cabin with their own hands is the most expedient way. All this is due to the fact that when choosing a ready-made solution, you face such difficulties as selecting a pallet, as well as its coverage, and many other difficulties. In addition, you will need to pick a booth strictly in the size of the room, and you can not be completely sure that it will be suitable. We can say that with factory cabs usually there is a lot of problems, while their design, too, leaves much to be desired. It's hard to say that a rustic plastic box is generally able to decorate the interior of a room.

Shower cabin with own hands: how to make it

From materials for its creation it is necessary to stock upgas silicate blocks, mortar for screed, tile glue, tile, foil for sealing seams, metal profile, moisture resistant plasterboard, metal screws, dowel nails, as well as pipes designed to provide inflow and outflow of water. If you talk about tools, then you should have at hand a special trowel for tiles, a rasp for blocks, a trowel, a drill, a sponge, a rule-level, a screwdriver. First of all, you need to determine the place where you will install the shower enclosure yourself. At this point, you should arrange a cavity, where then we will lead the pipes to drain the water into the sewer system. After the pipes have been installed, the cavity will be raised due to the fact that it will be flooded with a screed solution that lifts the floor height in this place by 5 centimeters. The filling is carried out so that the drain pipe remains in the center of the cavity.

If we talk about how the shower is donecabin with their own hands, then we should say that at the next stage we should start building walls. If you have chosen for your shower corner of the room, then the wall should be built only on one side, and when positioned in the center, you will need to build walls on both sides. Doing walls better from plasterboard, as it has a lot of advantages, such as ease of installation, lightness, strength, quality and all this with the minimum thickness of the partition. To install gypsum boards, you need to install the profiles from which the frame will be constructed. It should be noted that the drywall for these purposes should be moisture resistant. As a result, you will get a sufficiently strong partition, the thickness of which is approximately 10 centimeters.

The shower is almost ready by the hands, nowshould do the finishing. To do this you need to buy in the sanitary ware shop semi-circular sliding doors for your cabin, different taps, shower rain, you can buy a hydromassage and stuff. Now the doors can be installed on the shower walls. You must bring the pipes for water inflow, then install the fasteners for the cranes, rain, whirlpool and other. After this is done, you can begin laying the tiles. The pallet is best covered with tiles with good texture, preventing slipping. It is stacked on a pallet in such a way that it has a slope towards the center, which will allow the water to flow smoothly. Now the tiles should be laid on the walls of the shower room. Tile glue, used in these operations, should be the same moisture-resistant as plasterboard.

After laying the tiles, you can planseams tiles, followed by installation of shower appliances. Tiles should be ground using a special mixture containing antifungal additives. After all has dried, the tile must be rinsed to remove the fugue from the surface.

The shower cabin with its own hands is done very simply and quickly, and it serves much longer than its factory counterparts.